Journal of Magnetic Resonance

Volume 270, September 2016, Pages 47-55
Journal of Magnetic Resonance

gr-MRI: A software package for magnetic resonance imaging using software defined radios

https://doi.org/10.1016/j.jmr.2016.06.023Get rights and content
Under a Creative Commons license
Open access

Highlights

  • Software was developed for MRI using software-defined radios.
  • It implements sequencing functionality, and calibrations and image reconstruction.
  • It includes three common imaging sequences.
  • It was validated in 0.5 Tesla MRI experiments.
  • It enables the development of custom MRI spectrometers using off-the-shelf SDRs.

Abstract

The goal of this work is to develop software that enables the rapid implementation of custom MRI spectrometers using commercially-available software defined radios (SDRs). The developed gr-MRI software package comprises a set of Python scripts, flowgraphs, and signal generation and recording blocks for GNU Radio, an open-source SDR software package that is widely used in communications research. gr-MRI implements basic event sequencing functionality, and tools for system calibrations, multi-radio synchronization, and MR signal processing and image reconstruction. It includes four pulse sequences: a single-pulse sequence to record free induction signals, a gradient-recalled echo imaging sequence, a spin echo imaging sequence, and an inversion recovery spin echo imaging sequence. The sequences were used to perform phantom imaging scans with a 0.5 Tesla tabletop MRI scanner and two commercially-available SDRs. One SDR was used for RF excitation and reception, and the other for gradient pulse generation. The total SDR hardware cost was approximately $2000. The frequency of radio desynchronization events and the frequency with which the software recovered from those events was also measured, and the SDR’s ability to generate frequency-swept RF waveforms was validated and compared to the scanner’s commercial spectrometer. The spin echo images geometrically matched those acquired using the commercial spectrometer, with no unexpected distortions. Desynchronization events were more likely to occur at the very beginning of an imaging scan, but were nearly eliminated if the user invoked the sequence for a short period before beginning data recording. The SDR produced a 500 kHz bandwidth frequency-swept pulse with high fidelity, while the commercial spectrometer produced a waveform with large frequency spike errors. In conclusion, the developed gr-MRI software can be used to develop high-fidelity, low-cost custom MRI spectrometers using commercially-available SDRs.

Keywords

Software-defined radio
Spectrometers
Open-source software
MRI
Frequency-swept RF pulses

Cited by (0)