What are the cylinder head timing marks for a fe mazda engine 2.0? The guy who rebuilt the head took the pully out to

This is for a yale forklift.

The model number number glp05ordnual086lps

type lps

it has the original mazda FE engine with the

FE79 cylinder head.

I

It has A B C and Dot .... What i want to know is how to put the pulley on the camshaft. ..because the camshaft has a dot that goes into one of the three holes on pulley. . So basically there are 3 different ways i can put .. But i want the right one. ....

Thanks koboma.

The camshaft has a dowel pin but the pulley has three holes that go on the dowel pin. . meaning that i can put it in three different positions...

do you know which way is the dow pin supposed to be pointing when in time ?

I tryed to upload but it doesnt let me ...

No sign dowel was in hole and all holes are the same . And sero mating marks ..... Which way should the dowel be pointing without the pulley on? because once i know that i know that that B or the Dot should be pointing to the arrow at 12°

I can wait. . And thanks i really need yo figure this out .. Thanks

Ok

So the pin on the camshaft has to be pointing at 12°? Because the pulley has three holes and each holes pointing to A B C. ... And then it also has a dot ...but the dot does not macth up with the pin on the camshaft so to which letter should i alighn the pin on the camshaft with the pulley ...A B or C ?

Ok and once the pin is alighn with the A .... The timing mark on the pulley the dot has to alight with the arrow at 12° right?

One more thing just to make sure. ... After i alingh the dot on pulley with timing mark at 12°... The pin/dot on camshaft should be pointing to 9° ?