Available from:
Banggood.com
Aliexpress.com
Amazon.de
Manufacturer:
Blitzwolf.com
Install method:
Tuya-Convert
GPIO # | Component |
---|---|
GPIO00 | Led2i |
GPIO01 | User |
GPIO02 | Led1i |
GPIO03 | User |
GPIO04 | None |
GPIO05 | BL0937 CF |
GPIO09 | None |
GPIO10 | None |
GPIO12 | HLWBL SELi |
GPIO13 | Button1 |
GPIO14 | HLWBL CF1 |
GPIO15 | Relay1 |
GPIO16 | None |
FLAG | None |
WARNING: New Tuya devices have replaced their Wi-Fi module with one incompatible with Tasmota!!!
Tuya-Convert might not be possible for this device since the template was added ().
Hardware Revision
There is a newer hardware revision (v2.3) working with this template:
Tuya-Convert
Since SHP2 is a Tuya based device, Tuya-Convert flash is possible.
This method does’t need any wiring.
Serial Flashing
Please see the Hardware Preparation page for general instructions.
Step 1.
Be sure it is NOT plugged in! Remove the 4 triangle screws. Triangular 2.3mm Screwdriver required (a Torx T6 works well too)!
Step 2.
Solder cables to the ESP Pins
Step 3.
Connect serial adapter and make a shortwire between Pin IO0 and GND during startup. (For entering flashmode) RX and TX must be crossed.
Step 4.
Flash Tasmota
Pin layout hardware revision v2.4
Template for revision v2.3 is working, only the pin layout has changed.
OpenHab configuration
sonoff.items:
default.sitemap:
Home Assistant configuration
configuration.yaml