The following registry key is the primary location for registry settings for Windows File Protection/System File Checker:In addition, Windows File Protection/System File Checker settings may also be located in the following registry key:

When Windows starts up, the Windows File Protection service synchronizes (copies) the WFP settings from the following registry keyto the following registry key: Therefore, if any of the following values are present in the HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows NT\Windows File Protection key, they will take precedence over the same values under the HKEY_LOCAL_MACHINE\Software\Microsoft\Windows NT\CurrentVersion\Winlogon key.

By default, only users with Administrator or System rights can modify these settings.

Registry Values

SFCDisable (REG_DWORD)

0 = enabled (default)
1 = disabled, prompt at boot to re-enable
2 = disabled at next boot only, no prompt to re-enable
4 = enabled, with popups disabled

NOTE: For options 1 and 2: Both of these options require a kernel debugger to be hooked up for those options to become useable. If a kernel debugger is not hooked up, Windows File Protection is not disabled.

SFCScan (REG_DWORD)

0 = do not scan protected files at boot (default)
1 = scan protected files at every boot
2 = scan protected files once

SFCQuota (REG_DWORD)

n = size (in megabytes) of dllcache quota (default is 0xffffffff or approximately 300 MB)
FFFFFFFF = cache all protected system files on the local hard disk

SFCDllCacheDir (REG_EXPAND_SZ)

Path = local or network location of dllcache folder (default is %SystemRoot%\System32)

NOTE: Network shares for the dllcache directory are no longer supported.

SFCShowProgress (REG_DWORD)

0 = System File Checker progress meter is not displayed (default)
1 = System File Checker progress meter is displayed

NOTE: The Windows 2000 source files location information is stored in the following registry location and can be modified to point to the drive letter of a volume that has an I386 flat folder of the installation files or change the SourcePath value in the registry to point to a Universal Naming Convention (UNC) path instead of a mapped network drive.

The SourcePath value is located in the following registry key: Example:

If the I386 directory is at C:\I386, the SourcePath value would be C:\.

If the I386 directory is at \\Servera\w2kflat\I386, the SourcePath value would be \\Servera\W2KFlat.

After you restart the computer, WFP and SFC /SCANNOW uses the new source path instead of prompting for the Windows 2000 installation CD-ROM.